When Other Panasonic Products
Respond to this Remote Control
Use this function to synchronize the codes for the remote
control and the main unit when there are other Panasonic
products close to your unit.
With the unit stopped
Press [FUNCTION MENU].
Press [e, r] to select “To Others” then press [OK].
Press [e, r] to select “Setup” then press [OK].
Press [e, r] to select “Others” then press [q].
Press [e, r] to select “Remote Control” then
press [OK].
Press [e, r] to select the code (“DVD 1”, “DVD 2”
or “DVD 3”) then press [OK] to set.
Setup
Tuning
Disc
Picture
Sound
Display
Connection
Others
Remote Control
Press
“
”
and
“
OK
”
together
for more than 5 seconds on the remote
control.
OK
RETURN
While pressing and holding [OK],
press and hold the numbered button [1], [2] or [3]
corresponding to the code set in step 6 for more
than 5 seconds to set.
8
Press [OK] to complete.
When the following indicator appears on the unit’s display
Change the code on the remote control to match the code
displayed for the main unit (➔ step 7).
Tips
To return to the previous screen
Press [RETURN].
To exit the screen
Press [EXIT].
–
To reset this unit
To reset the unit’s settings
All the settings except for the ratings level, ratings
password, Owner ID and Clock return to the factory preset.
The timer recording programmes are also cancelled.
On the main unit
Press and hold [2 CH] and [CH 1] for about 5
seconds.
Refer to Tips of “Auto-Setup Restart”
(➔ 47) for detail information.
To reset the ratings level settings
With the unit stopped
Press [; OPEN/CLOSE] to open the disc tray.
On the main unit
Press and hold [* REC] and [q/x1.3] for about 5
seconds.
To restore the unit if it freezes
On the main unit
Press and hold [8] for more than 10 seconds.
The unit is turned off.
–
–
Troubleshooting Guide
RQT8856-BDTP070306.indb61RQT8856-BDTP070306.indb61 2007/04/0417:49:442007/04/0417:49:44
To Next Page
Loading...
Need help?
General
