11
Getting Started
Supplying Power
1 Slide the Battery upward while sliding
the
BATTERY RELEASE to remove
the Battery (page 10).
2 Insert the DC Cable into the DC IN
Terminal.
3 Connect the other end of the DC
Cable to the AC Adaptor as shown.
4 Plug in the AC Adaptor.
• The POWER Lamp of the AC Adaptor
lights up.
• When not in use, unplug the AC Adaptor
from the AC outlet. (AC Adaptor
consumes 1W of electric power when
plugged into an AC outlet even when not
in use.)
DC Cable
(Supplied)
DC IN Terminal
AC Adaptor
POWER
Lamp
BATTERY RELEASE Switch
Note
1
2
1
2
3
DC IN Terminal
100-K.10-17.p65 00/06/14, 11:5411
To Next Page
Loading...
