53
Special Features
2
4
To PC Connector
PC Connection
PHOTOVU Link Driver
System Requirements for PHOTOVU LINK Driver
• IBM PC/AT or compatible.
• Intel
®
Pentium
®
Processor
• Microsoft Windows
®
95 or Windows
®
98
• RAM: 16 MB or more
• 2 MB minimum available hard disk
space.
• 256 colour monitor (full colour
recommended).
• 3.5 inch 1.44 MB floppy disk drive
(for installation).
• RS-232C serial port (D-Sub 9-pin).
An adaptor (D-Sub 9-pin male to a
D-Sub female) is required for a D-
Sub 25-pin.
• Mouse or other pointing device.
RS-232C
(D-Sub 9-pin)
(Default is COM1.)
PC Connecting
Cable for Windows
(Supplied)
An image stored in the DV Tape can be transferred to your PC (Personal Computer).
Connection
1 Turn off your PC.
2 Connect the Digital Video Camcorder to your PC (Windows) using
the RS-232C PC connecting cable (supplied).
• Before connecting the Palmcorder to the PC, make sure the PC
power is off to insure that images are transferred properly.
3 Turn on your PC.
4 Set the Palmcorder POWER to VCR.
• For extended periods of use, it is recommended to use the AC Adaptor
as a power source.
• Refer to the PC or Windows manual to identify which COM port is to be
used for connection.
Note
100-K.53-56.p65 00/06/14, 11:5753
To Next Page
Loading...
