10
Supplying Power
To remove the Battery:
Slide the Battery upward while sliding the
BATTERY RELEASE Switch.
Caution:
• Charge only with specified charger.
• The Battery can be charged within a
temperature range of 32° F (0° C) and
104° F (40° C).
• The Battery may be warm after charging
or just after use. This is normal.
• Do not use an insufficiently charged or
worn out Battery.
• In extremely cold surroundings, Battery
charging time will increase.
Safety precautions:
• Do not get the Battery near, or dispose of
in, fire.
• Do not directly connect (short circuit) the
positive (+) and negative (–) terminals.
• Never attempt to disassemble or
reassemble the Battery.
To avoid damage to the Battery:
• Do not drop or jar the Battery.
• Use the Battery with specified models
only.
• If the Battery is used in extremely high
temperatures, a safety device will
automatically prevent operation.
To insure longer battery life:
• While not in use, remove Battery from
the Palmcorder and AC Adaptor and
store in a cool, dark, dry place. If you
leave the Battery in the Palmcorder or on
the AC Adaptor, the Battery will no longer
be rechargeable.
• Keep the Battery terminals clean.
BATTERY RELEASE Switch
Insert/Remove the Battery Pack
Battery Care
1 Tilt Viewfinder upward.
2 Insert the Battery and slide it down
until it locks with a click.
1
2
3
1
2
100-K.10-17.p65 00/06/14, 11:5410
To Next Page
Loading...
