Panasonic Digital Palmcorder PalmSight PV-DV100-K - Remote Control Operations; Controlling Multiple Palmcorders; Replacing the Remote Control Battery

32
DATE /
TIME
PHOTO
SHOT
REC /
PAUSE
A.DUB
MENU
STOP /
SET
INDEX
SEARCH
SLOW /
F.A DV
PAUSE /
SEL
SLOW /
F.A DV
REW / PLAY
FF /
- SPKR VOL +
T
W
INDEX
SEARCH
REC
CAMCORDER
CAMERA
DISPLAY
ON TV
COUNTER /
TC
RESET
Remote Control (Optional)
a
b
Replace battery with
Panasonic PART NO.
VSBW0004 (CR2025) only.
Use of another battery may
present a risk of fire or
explosion.
Caution-battery may
explode if mistreated.
Dispose of used battery
promptly. Keep away from
children. Do not recharge,
disassemble or dispose of
in fire.
1Insert a slender pointed
object, such as the tip of a
ball-point pen into the slot so
that it fits into the hole (as
shown a). Then, while sliding
to the right, pull the Battery
Tray out with your fingernail.
2Insert the battery into the
Battery Tray with the
+ mark
facing down.
Do not reverse the polarity.
3Insert the Battery Tray.
+
Replace the Battery
Optional
REMOTE
You can control any two Panasonic Digital
Video Camcorders with one Remote
control (Optional, page 57). In order for the
remote to distinguish between the two
units, it is necessary to set one of the
Palmcorders to VCR 2. On the remote,
press VCR 1 or VCR 2 to control the
desired Palmcorder.
For VCR 2 :
Press these
buttons at
the same
time.
For VCR 1 :
Press these
buttons at the
same time.
Remote Controlling Two
Palmcorders
Optional
Note
1Set the POWER to VCR or CAMERA.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
2 Press MENU to display the VCR or
CAMERA mode menu screen.
3 Rotate JOG KEY to select CAMERA
SET-UP in the CAMERA mode menu
screen or VCR PLAY MODE in the
VCR mode menu screen, then press
JOG KEY to display the CAMERA
SET-UP or VCR PLAY MODE menu
screen.
4 Rotate JOG KEY to select REMOTE ,
and then press JOG KEY to select
VCR 2 on one Palmcorder (pages 21,
23). Leave the other Palmcorder set to
VCR1.
5 Set the Remote Control (Optional,
page 57) to VCR 1 or VCR 2 to
correspond with the Palmcorder you
wish to control. (See illustration at left.)
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), “CHECK REMOTE MODE
(REMOTE)” will appear.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
100-K.28-33.p65 00/06/14, 11:5532