Panasonic Digital Palmcorder PalmSight PV-DV100-K - Special Features: Audio Dubbing and Memory-Stop Editing; Memory-Stop Editing Setup

49
Special Features
4 Press PAUSE to start Audio Dubbing.
• Connect the Palmcorder to the TV in
order to monitor the sound (page 38).
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
5 Press PAUSE to stop Audio Dubbing.
DATE /
TIME
PHOTO
SHOT
REC /
PAUSE
A.DUB
MENU
STOP /
SET
INDEX
SEARCH
SLOW /
F.A DV
PAUSE /
SEL
SLOW /
F.A DV
REW / PLAY
FF /
- SPKR VOL +
T
W
INDEX
SEARCH
REC
CAMCORDER
CAMERA
DISPLAY
ON TV
COUNTER /
TC
RESET
Special Features
RESET
Button
Memory-Stop Editing (Optional
Remote Control Only, page 57)
Optional
A-DUB
You can set an automatic Edit stopping
point.
MENU
Button
INCOMPATIBLE
TAPE
PAUSE Button
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position lies or starts in a blank
section, you cannot use the A-DUB
feature.
Before step 2, locate the point at which you
want the dubbing to stop.
Press
MENU to display the VCR menu
screen.
Rotate JOG KEY to select DISPLAY
SETTING , and then press
JOG KEY to
display the DISPLAY SETTING menu.
Rotate JOG KEY to select DISPLAY , and
then press
JOG KEY to set to MEMORY.
Then, press RESET on the remote control
to reset the Counter Memory to
M 0:00:00.
Now, rewind to the editing start point, and
continue with steps 2-5. The tape will now
stop automatically at “M 0:00:00”.
To listen to the desired audio sound, set
the AUDIO setting of the VCR mode MENU
(page 22) as follows:
AUDIO (The following selections are
available for 12 bit AUDIO dubbed
recording only)
ST 1 Set this position to listen to the
original sound.
ST 2 Set this position to listen to the
audio dubbed sound.
MIX Set this position to listen to both
the original sound and the audio
dubbed sound.
• 16 bit dubbed sound completely erases
the original 16 bit recorded sound.
• If you select 12 bit AUDIO recording and
dubbed the sound with the AUDIO-MIX
on, the sound will be in stereo regardless
of the AUDIO-OUT setting.
• If you recorded in LP mode, you cannot
use the A-DUB feature.
Note
100-K.46-52.p65 00/06/14, 11:5749