28
Remove the lens cap and clip it to the hook.
Before you begin...
• Connect the Palmcorder to a power source
(pages 10, 11).
• Insert a cassette with record tab closed
(page 13).
1 Set POWER to CAMERA.
• The POWER lamp lights red.
• Be sure POWER
is fully turned to
CAMERA position.
2 With the Viewfinder Eye Cup up to
your eye, adjust the Vision
Adjustment Control to your eyesight
(page 8).
3 Press RECORD/PAUSE to start
recording.
The Tally LED will be on.
To turn the Tally LED off, see TALLY
LED on page 21.
Press
RECORD/PAUSE again to
pause recording.
Record/Pause mode.
Camera Recording
EVF
To conserve power
After 5 minutes, the Record/Pause mode will
automatically change to Standby mode.
To resume recording, set POWER to OFF
and then ON again.
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the picture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
WARNING:
• Do not lift, or carry, the Palmcorder by
the EVF or the LCD Monitor.
POWER
Switch
RECORD/
PAUSE
Button
POWER
Lamp
TALLY LED
Lights during recording.
Simple Recording
Vision
Adjustment
Control
100-K.28-33.p65 00/06/14, 11:5528
To Next Page
Loading...
