50
Special Features
Video In
S-Video In
VHF Connecting
Cable (not
supplied)
TV
(To View)
A/V Cable
(Supplied)
To Audio In
To Video In
Recording:
VCR (Rear)
To S-Video In
(If there is S-Video In)
• For technical reasons, dubbing a tape may
reduce its quality.
• Press DISPLAY on the Palmcorder remote
control (optional, page 57) to eliminate EVF/LCD
Monitor indications to be recorded on the tape.
• If the Time Code is displayed in the EVF or LCD
monitor, this display cannot be reset.
CAUTION:
Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
A/V OUT
S-VIDEO OUT
Source
(Playing)
Palmcorder
Copying your Tapes to
S-VHS or VHS Cassette
Monitor with your TV
Before you begin...
• Connect both Palmcorder and VCR to their
power sources.
• Connect the Palmcorder to a VCR as
illustrated below.
• Turn ON both units.
• Set the recording VCR’s Input Signal
Selector to LINE.
• Set the Palmcorder POWER Switch to VCR.
1 Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
2 Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PAUSE.
3 Press REC or simultaneouslyREC
and PLAY (depends on VCR) and then
pause the recorder.
4 Simultaneously, press PAUSE on
both units to begin the copying.
5 Press STOP on both units when
copying is completed.
VCR Buttons
PAUSE/STILL
STOP
REW
PLAY
FF
REC
S-Video
Cable (not
supplied)
Audio In
Note
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
100-K.46-52.p65 00/06/14, 11:5750
To Next Page
Loading...
