33
Basic Operation
Before you begin...
• Connect the Palmcorder to a power source
(pages 10, 11).
• Insert a recorded cassette.
• Set Power to VCR.
Playback your Recordings
REWIND
SEARCH
Button
VOLUME KEY
STOP
Button
PLAY
Button
Built-in
Speaker
LCD-OPEN
Button
Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
180°
90°
1 Press LCD-OPEN to unlock the LCD
monitor and swing open.
2 Press REWIND/SEARCH to rewind
the tape.
3 Press PLAY to start playback.
To adjust the volume:
Hold down
VOLUME KEY until the volume
setting screen appears (page 25). Then
rotate
VOLUME KEY to adjust the volume
of the built-in speaker. Hold down the
VOLUME KEY again to make the volume
setting screen disappear.
•Adjust the picture on the LCD monitor if
needed (page 29).
4 Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press
PLAY for more than
5 seconds, the Palmcorder will start
the Repeat Playback mode when the
tape reaches its end. The letter “R
”
will appear in the EVF
and LCD monitor.
To exit the Repeat
Playback mode,
turn the
Palmcorder OFF.
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
• Connect earphones (not supplied) to the
PHONE Jack.
Note
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.
PHONE
Jack
100-K.28-33.p65 00/06/14, 11:5533
To Next Page
Loading...
