48
DATE /
TIME
PHOTO
SHOT
REC /
PAUSE
A.DUB
MENU
STOP /
SET
INDEX
SEARCH
SLOW /
F. ADV
PAUSE /
SEL
SLOW /
F. ADV
REW / PLAY
FF /
- SPKR VOL +
T
W
INDEX
SEARCH
REC
CAMCORDER
CAMERA
DISPLAY
ON TV
COUNTER /
TC
RESET
Special Features
Before you begin...
• Connect the external Microphone (if used).
• Turn on the Palmcorder.
• Insert a pre-recorded tape to be dubbed.
External Microphone
with M3 connector
(not supplied)
External
Microphone Jack
The AUDIO-REC setting in CAMERA MENU
mode should be as follows:
12 bit The original sound is recorded on ST
(Stereo) 1, and the new sound will be
recorded on ST (Stereo) 2.
16 bit The original sound is replaced with
the new sound.
• Select 12 bit if you do not want the original
sound to be completely replaced during an
audio dub.
• If you dub over a tape which has both 12
bit and 16 bit audio recordings on it, keep
in mind that the original 16 bit audio
portion will be completely replaced.
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone or an external microphone.
Audio Dubbing using the
External or Built-in Microphone
PLAY Button
PAUSE Button
A.DUB Button
(Continued on next page.)
A.DUB
Button
Optional
A-DUB
1 Set POWER to VCR.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
VCR position.
2 Press PLAY.
Then press
PAUSE where you want
dubbing to begin.
3 Press A.DUB on this unit (for three
seconds) or on the remote control
(optional, page 57) to put the
Palmcorder in the Audio Dub mode.
•“A.DUB” flashes in the EVF or the
LCD monitor.
EVF/LCD Indication
100-K.46-52.p65 00/06/14, 11:5748
To Next Page
Loading...
