14
Colour Enhancement Light (Optional)
1 Slide Light into the Built-in Light
Mount.
Be sure it locks into place.
2 Press LIGHT ON.
3 Press LIGHT again to turn OFF.
To remove the Light:
Press
LIGHT RELEASE and slide the Light
out of the mount.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
To brighten the natural colours in a scene.
• Using the light will reduce battery operating time.
• If using the Enhancement Light for an extended period of time, be sure to provide
ventilation when using it in a hot environment.
• Be sure LIGHT is set to OFF when not in use.
• Do not attempt to lift or carry the Palmcorder by holding the Enhancement Light.
• If light bulb needs to be replaced, take Light to your nearest authorized servicentre.
LIGHT ButtonLIGHT RELEASE
Button
Using the Light
Note
Before you begin...
• Connect the Palmcorder to a power source
(pages 10, 11).
• Set POWER to CAMERA.
Built-in Light Mount
100-K.10-17.p65 00/06/14, 11:5414
To Next Page
Loading...
