6.2 When the Forcible Disc Eject can not be done.
TOP PREVIOUS NEXT
1. Turn off the power and pull out AC cord.
2. Remove the Top Case.
3. Remove the Front Panel.
4. Remove 4 screws and Upper Base Unit from DVD-RAM Drive.
5. Take out the disc and put the Opener Roller on fully position for direction of Arrow.
6. Put the Upper Base Unit so that the Opener Roller is inserted into the groove.
7. Check center of Opener Roller is seen through the Opener position Checking Hole, and tighten 4
screws.
To Next Page
Loading...
