14.8. VTR Mechanism Unit
1. Disconnect 3 Connectors (P1531, P2501 and P4002).
2. Remove 3 Black Screws (A), Screw (B) , Screw (C) and
Screw (D).
3. Lift up VTR Mechanism Unit perpendicula rly so to
disconnect Connectors (P2571 and P3001).
Note:
Pay attention to stiff connections of P2571 and P3001,
when removing VTR Mechanism Unit.
14.8.1. Caution for attaching VTR
Mechanism Unit
1. Because Position SW should be set to "Eject Position",
refer to fig.(A) and set the position switch so that the boss
and arrow mark come on a straight line.
2. Attach VTR Mechanism Unit so that Boss of Position SW is
put into long hole of Main Cam Gear, refer to Fig. (B).
36
DMR-ES30 VP / DMR-ES30 VPC
To Next Page
Loading...
