Panasonic DMR-EZ47VP

Error Code Diagnosis contents Description Monitor Display Automatic FL display
PLEASE
WAIT
Unit is in termination process Unit is in termination process now.
“BYE” is displayed and power will be turned
off.
In case “Quick Start” of setup menu is ON, it
is displayed in restoration operation for AC
off.
No display
“0” is displayed one by one.
UNFORM
AT
Unformatted disc error You have inserted an unformatted DVD-RAM
or DVD-RW that is unformatted or recorded
on other equipment.
7.1.2. (DVD) Special Modes Setting
Item FL display Key operation
Mode name Description Front Key
TEST Mode *All the main unit´s parameters are initialized. Press [VHS to DVD COPYING],
[REC] and [OPEN/CLOSE] keys
simultaneously for five seconds
when power is off.
Rating password The audiovisual level setting password is
initialized to “Level 8”.
No display When the power is on (E-E mode).
While the tray is open, press [REC]
and [PLAY] simultaneously for 5
seconds.
Service Mode Setting every kind of modes for servicing.
*Details are described in “7.1.3. (DVD)
Service Modes at a glance”.
When the power is off, press [VHS
to DVD COPYING], [OPEN/CLOSE]
and [STOP] keys simultaneously for
5 seconds.
Forced disc eject Removing a disc that cannot be ejected.
The tray will open and unit will shift to P-off
mode.
*During Schedule Recording, Forced disc
eject is invalid.
While Demonstration Lock is being set, this
Forced disc eject function is not accepted.
The display before execution
leaves.
When the power is off, press
[STOP] and [CH UP] keys
simultaneously for 5 seconds.
Forced power-off When the power button is not effective while
power is ON, turn off the power forcibly.
*When Schedule Recording is ON, execute
“Forced Power-off” after releasing Schedule
Recording.
Display in P-off mode. Press [POWER] key over than 10
seconds.
Aging Perform sequence of modes as * Aging
Description shown below continually.
Display following the then mode. Set DRIVE SELECT to DVD.
When the power is ON, press [CH
DOWN], [VHS to DVD COPYING]
and [OPEN/CLOSE]
simultaneously for over 5 seconds
and less than 10 seconds.
NOTE1:
If Unit has not turned into Aging
mode by operations shown above,
execute TEST MODE once and re-
execute operation shown above.
(*All the main unit’s parameters are
initialized by TEST mode.)
NOTE2:
If the unit has hung-up because of
pressing keys for over 10 seconds,
once turn off the power, and re-
execute this command.
*When releasing Aging mode,
press [POWER] key, AC-OFF.
18
DMR-EZ47VP / DMR-EZ475VP