EasyManua.ls Logo

Panasonic DMR-XW440

Panasonic DMR-XW440
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
SQT0134
87
The remote control does not work.
The remote control and main unit are using
different codes. Change the code on the remote
control.
Software (firmware) is updating when “UPD
/” is displaying on the units display. Wait until
the update is completed. (> 81)
The HOLD function is activated. (> 85)
Startup is slow.
Startup takes time in the following situations:
- A disc is inserted.
- The clock is not set.
- Immediately after a power failure or the AC
mains lead is connected.
- When the “Quick Start” is not activated. (> 79)
Startup of this unit may be slower depending on
the TV settings.
“0:00” is flashing on the unit’s display.
Set the clock. (> 70, 80)
The clock does not display on the unit when
switched to standby.
The clock does not display when “Quick Start” is
not activated. (> 79)
Screen size is wrong.
Check the “TV Aspect” or “Aspect for 4:3 Video”.
(> 76)
Adjust the aspect ratio setting on TV.
If you connect to 4:3 TV, set “HDMI Video
Format” to “576p/480p”. (> 70, 76)
Check “Aspect for Recording” before recording
or file conversion. (> 70, 73)
The black screen appears on the TV.
This phenomenon may occur, depending on the
TV setting, when “Quick Start” is activated.
Depending on the TV, this phenomenon may be
prevented by reconnecting to a different HDMI
input terminal.
TV reception is not displayed.
Broadcast signals are not output from this unit’s
RF OUT terminal. Select “On” in “RF OUT
( Aerial Signal )”. (> 70, 79)
Picture does not appear with the HD quality
although HD setting was made.
The pictures are output with 576p/480p
depending on the title.
The screen changes automatically.
If “Screen Saver” set to “On”, the screen saver
function will be activated when there is no
operation for 5 minutes or more. (> 76)
There is a lot of image lag when playing video.
Set to “0” all items in the “Noise Reduction”.
(> 69)
Set “Audio Delay”. (> 70, 75)
Unit's display
Press and hold [OK] and
the indicated number
button at the same time
for more than 5 seconds.
(> 79)
Displays
TV screen and video
DMRXW440GL_eng.book 87 ページ 2014年2月6日 木曜日 午前11時29分

Table of Contents

Related product manuals