Pre Installation Information
108
To install your machine as SMTP Mail Server, the following network parameters need to be programmed on
your network and on your machine.
• TCP/IP Address of your machine
• TCP/IP Subnet Mask of your machine
• TCP/IP Address of the Default Gateway
•Host Name
• TCP/IP Address of the DNS Server (if not available, see Note 2)
• Email Address of your machine (see Note 1)
• Name or IP Address of the Default SMTP mail server
• SMTP Authentication Name (when the authentication with the SMTP server is required)
• SMTP Authentication Password (when the authentication with the SMTP server is required)
Email (from your machine to a PC) and Direct Internet Fax XMT Transmission
Email (from a PC to your machine) and Direct Internet Fax XMT Reception
NOTE
1. To function as SMTP mail server, your machine's email address must include its unique Host
name within your company domain. This unique Host name must be registered within your
network’s DNS (Domain Name System) server. Example: Internet_Fax@fax01.panasonic.com
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter
the SMTP Server Name.
If the DNS Server is not available, change the 27(DNS Server Address)(For DP-2330/3030),
26(DNS Server Address)(For DP-3530/4530/6030) of General Settings to "No".
(For DP-2330/3030)
Press , Input ID Code,
.
(For DP-3530/4530/6030)
Press , Input ID Code,
.
Then the machine will prompt you to enter the IP Address of the SMTP Server.
Setup as SMTP Mail Server
ifaxuser@fax01.panasonic.com
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
Gateway(Router)
popuser001@panasonic.com
SMTP
POP3
Direct Internet Fax XMT
ifaxuser@fax02.panasonic.com
ifaxuser@fax01.panasonic.com
SMTP01.panasonic.com
(SMTP Mail Server)
Gateway(Router)
popuser001@panasonic.com
SMTP
Direct
Internet Fax
XMT
ifaxuser@fax02.panasonic.com
FUNCTION
GENERAL SETTINGS 09 Key Operator Mode
OK
27 DNS Server Address
FUNCTION
GENERAL SETTINGS 04 Key Operator Mode
OK
26 DNS Server Address