Panasonic DP-2330

Customizing Your Machine
193
Fax Parameter Table
Setting Your
Machine
097 Special Tray
No.1 - 4
(DP-2330/3030: No.1 - 3)
*None Select up to 4 Special Trays that will not be used for printing received
faxes (4-Trays, plus LCT configuration). One Tray must always be
available for receiving Faxes.
(You can specify one Tray (1 ~ 4, LCT) for each selection No. 1, No. 2,
No 3 and/or No. 4)
(DP-2330/3030: 4-Trays only)
Tray 1
Tray 2
Tray 3
Tray 4
LCT
099 Memory Size
(Flash Memory)
- Displays the amount of base and optional memory installed.
(Base Memory + Optional Memory)
118 FAX Function Detect Invalid Setting the number of digits for detecting a Fax Telephone number.
Upon detecting the specified number of digits, the machine will
automatically switch to the FAX Mode when it is in the Copier Mode.
4-Digits
5-Digits
*6-Digits
7-Digits
8-Digits
140 LAN Relay XMT Request *Invalid Selecting whether the machine performs LAN Relay XMT Request.
Valid
141 LAN XMT Reduce *Invalid Selecting whether to automatically reduce from LEDGER / B4 to A4,
when LEDGER / B4 documents are transmitted via LAN.
Invalid :No reduction
Valid :Automatic reduction from LEDGER / B4 to A4
Valid
142
Relay XMT
(a.k.a. LAN Relay Station
on UF-770i)
Invalid Selecting whether the machine accepts and performs G3 relayed
transmission. (Relay Station Functions)
*Valid
143 Relay XMT Report Off Setting how the COMM. Journal for relayed transmission is sent to the
originator.
Off : Don’t send.
Always : Always send.
Inc. only : Send only if communication has failed.
*Always
Inc. only
144 Email Character Set Japanese Selecting the Character Set when receiving or sending email text.
*English
145 Sender Selection *Invalid Selecting a pre-programmed sender’s name and email address before
each transmission.
Valid
146 POP Timer 0 to 60 min. Setting the time interval for the machine to check for email on the POP
Server.
(0 = Does not check the POP Server for email.)
147 Auto POP Receive Invalid Selecting whether the machine automatically downloads an email from
the POP Server.
*Valid
* = Factory default setting
No. Parameter Setting Comments
Continued on the next page...