Panasonic DP-MB300

6. Copier
36
6 CopierCopy
6.1 Making a copy
6.1.1 Using the scanner glass
1
If the {D} light is OFF, turn it ON by pressing {D}.
2 Set the original (page 20).
3 If necessary, change the resolution and contrast
according to the type of document.
L To select the resolution, see page 36.
L To select the contrast, see page 36.
4 If necessary, enter the number of copies (up to 99).
5 {X}
L If the copy input tray prompt (feature #471 on
page 63) is activated, select the desired
recording paper size by pressing {V} or {^}
repeatedly, then press {X} again.
L The unit will start copying.
6 After you finish copying, press {W} to reset the
settings you set in step 3 and 4.
Note:
L To stop copying, see page 74.
L You can change the default operation mode (feature
#463 on page 57) and the timer before returning to
the default operation mode (feature #464 on page
57).
L If the {V/K} light is ON, the unit can receive faxes
automatically even when in the copy mode.
To select the resolution
1. Press {G}/{H} repeatedly.
– “TEXT/PHOTO”: For both text and photographs.
– “TEXT”: For text only.
– “PHOTO”: For photographs, shaded drawings,
etc.
2. {OK}
Note:
L You can change the default resolution (feature #461
on page 63).
To select the contrast
Adjust this setting depending on the darkness or
lightness of the document. 5 levels (low to high) are
available.
Press {F} repeatedly. i {OK}
Note:
L You can hold the previous contrast setting (feature
#462 on page 57).
{OK}{V}{^}
{D} (Copy)
{F} (Contrast)
{G}/{H} (Resolution)
{V/K} (Fax Auto Answer)
{W} (Stop)
{X} (Start)