Panasonic DP-MB300

8. Programmable Features
64
8.5 PC print features
Feature/Code Selection
Setting the paper input tray in
PCL
{#}{7}{6}{0}
This feature will be displayed only when the lower input tray is installed (page
74).
{1} “#1” (default): Standard input tray
{2} “#2”: Lower input tray
{3} “#1+#2”
Note:
L To sel ect “#2”, select “PLAIN PAPER” or “THIN PAPER” for the recording
paper type setting (feature #383 on page 57).
L To se lect “#1+#2”,
– select the same paper size for the standard input tray (feature #380 on
page 57) and lower input tray (feature #382 on page 57). If either is
changed, “#1” will be selected automatically.
–select “PLAIN PAPER” or “THIN PAPER” for the recording paper type
setting (feature #383 on page 57).
Setting the number of copies
in PCL
{#}{7}{6}{2}
1. {Y} i {#}{7}{6}{2} i {OK}
2. Enter the number of copies from “001” to “999”, using the dial keypad.
L The default setting is “001”.
3. {OK} i {Y}
Setting the recording paper
size in PCL
{#}{7}{6}{3}
{1} “LETTER”: Letter-size paper
{2} “A4” (default): A4-size paper
{3} “LEGAL”: Legal-size paper
Setting the image reduction
feature in PCL
{#}{7}{6}{4}
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): The document resolution will be automatically reduced
when the data size is too large to print.
Note:
L This feature may lower the print quality by reducing the resolution.
Setting the recording paper
direction in PCL
{#}{7}{6}{5}
{1} “PORTRAIT” (default): The document will be printed in portrait direction.
{2} “LANDSCAPE”: The document will be printed in landscape direction.
Setting the A4 wide feature in
PCL
{#}{7}{6}{6}
You can change the margin and printable area of A4-size recording paper so
that 80 characters in 10 cpi font may be printed on a line.
{0} “OFF” (default): Deactivates this feature.
{1} “ON”: The margin and printable area of A4 recording paper will be changed.
Setting the lines per page in
PCL
{#}{7}{6}{7}
To set the number of lines per page in PCL printing.
1. {Y} i {#}{7}{6}{7} i {OK}
2. Enter the number of lines per page from “005” to “128”, using the dial
keypad.
L The default setting is “064”.
3. {OK} i {Y}
Setting the font source in PCL
{#}{7}{6}{8}
This feature is available when the downloaded font is registered to the unit.
{1} “RESIDENT” (default): The document will be printed using resident font.
{2} “DOWNLOAD FONT”: The document will be printed using download font.