6. Copier
38
Example: 150 % enlarged copy
Using the scanner glass (1):
Using the automatic document feeder:
Example: 70 % reduced copy
Using the scanner glass (1):
Using the automatic document feeder:
6.2.2 Collate copy
The unit can collate multiple copies in the same order as
the original document pages.
1 Set the original (page 20).
2 Press {E} repeatedly to display “ON”.
3 {OK}
4 Enter the number of copies (up to 99).
5 When using the scanner glass:
1. {X}
L The unit will scan 1 page.
2. Place the next document on the scanner glass
and press {OK}. Repeat this until you have
scanned all pages, and then press {X}.
L The unit will start copying.
When using the automatic document feeder:
{X}
6 After you finish copying, press {W} to reset this
feature.
Example: Making 2 copies of a 4-page original
document
Note:
L The unit will store the documents into memory while
collating the copies. If the memory becomes full
while storing, the unit will only print out the stored
pages.
L You can hold the previous collate setting (feature
#469 on page 63).
Proof set feature
To make 1 set of a collated copy first, press {E}
repeatedly to display “PROOF SET” (step 2 on
“6.2.2 Collate copy”, page 38). The unit will make 1 set of
a collated copy and stop temporarily so you can check
whether the copy was made as you expected. If the copy
is correct, press {X} to continue copying.
If the copy is not correct, press {W} and start again from
the beginning.
6.2.3 Duplex copy
You can make 2-sided copies of 1-sided documents.
L A4, letter or legal-size recording paper (plain and
thin) can be used.
1 Set the original (page 20).
2 {C}
3 Press {V} or {^} repeatedly to select the desired
binding.
– “LONG EDGE”
Original document Enlarged copy
Original document Enlarged copy
Original document Reduced copy
Original document Reduced copy
1
1
Collated pages Uncollated pages
4
3
2
1
4
3
2
1
4
4
3
3
2
2
1
1