Troubleshooting Guide
Problem
Cause & Remedy
l
The unit does not work when I push any Plug in the AC adaptor then switch
buttons. the power on.
01 cannot remove the cassette from the unit.
(The unit has been set to the Answer mode,
l
The OGM or KM cassette is cut or \
but no Incoming Message is recorded. is not inserted. Replace the cassette
with a new one.
l
The OGM is recorded improperly.
Record a new OGM.
J
The unit does not function. However, the
l
OGM cassette might be broken.
beep sounds 6 times and the Replace it with a new one.
ANSWER/CALL indicator flashes on and off
l
Ciean the heads. (See page 24.)
quickly.
I
‘While recording an Outgoing Message, the
Rerecord your Outgoing Message. ’
beep sounds 6 times. Speak clearly and loudly, and do not
pause for over 2 seconds while
\.
recording.
J
‘When the Outgoing Message or the
\
l
Clean the Heads. (See Maintenance
Incoming Message tape is played back, the
instruction on page 24.)
sound level is low, even if the VOLUME
\ control is turned up fully.
/
I have played back all the recorded
l
Wait for 7 seconds. The unit will be
messages and I want to record the next ready to record the next phone call.
phone call after the last previously recorded
l
ln case of the remote operation,
message. hang up.
push the button of a remote phone, but the
l
Make sure that you are entering
does not respond.
correct Code number.
oRecord the Outgoing Message in a
quiet place.
Some Incoming Messages have not been
Set the CPC switch to “B”.
recorded up to their end. (See page 5.)
The ICM tape continues to run after a caller Set the recording time selector to
hangs up.
“1 MIN”.
- 20 -
:
To Next Page
Loading...
