How to Record an Outgoing Message (OGM)
Before operating your unit, you must record an Outgoing Message (OGM).
The OGM will inform the calling party of your absence and your message.
RECORDING THE OGM
POWER/IN USE Indicator
1 Push OGM REC until a long beep is
heard, then release it.
2 After the long beep, speak clearly and
loudly into the microphone (MIC),
approximately 8 inches away.
l
The IN USE indicator will flash.
l
The recording time is up to the tape
length that you use.
3 When recording is finished, push OGM
REC again.
l
The unit will rewind the tape to the
beginning, and be ready for Incoming
Calls.
NOTE:
If you pause for over 2 seconds while
recording, you will hear a series of warning
tones (6 beeps) and the unit will start
rewinding the tape. If this happens, start with
step 1 again after the unit stops rewinding.
-7-
To Next Page
Loading...
