Preparation
INITIAL SETTINGS
Calling Party Control (CPC) Setting
Set to “A”. (no call waiting service line.)
If you have call waiting service or
some Incoming Messages are
interrupted, set to “B”.
02 __............ The unit will answer a call on the
l
AUTO......
Recording
l vox . . . . . . . .
01 minute..
(1 MIN)
See “TOLL SAVER” on this
page.
Time Selector
The unit will record for as long as
the caller speaks.
The unit will record up to I minute.
Remote Code
The remote code number is made up of
2 digits.
The first digit is factory preset, and the
second digit is selectable. (2 or 8)
Also, refer to page 14 for your remote code
setting.
TOLL SAVER
The TOLL SAVER feature lets you avoid a toll charge when you call your unit and no
messages have been recorded.
1 Set the number of rings to AUTO.
elf the unit does not pick up on the third ring, hang up immediately. This means that
you have no messages and you have saved a toll charge.
n
The unit picks up on the second ring:
It means that at least one message has been recorded.
n
After you have played back all the messages from a remote phone, the unit will pick
up the next call on the fourth ring. If the unit picks up on the second ring, it means
that at least one new message has been recorded.
-5-
To Next Page
Loading...
