- 100 -
Connecting with a HDMI mini cable
Select the desired method of HDMI output.
≥ [AUTO] determines the output resolution automatically based on information from the
connected TV.
If the images are not output on the TV when the setting is [AUTO], switch to the method
[1080p], [1080i] or [576p] which enables the images to be displayed on your TV. (Please
read the operating instructions for the TV.)
≥ Image will not display on TV for a few seconds in the following cases.
jWhen the 1080/50p recording mode is turned on/off during Motion Picture Recording
Mode
jWhen you touch the play mode select icon to select [1080/50p] and then touch [ENTER]
during Playback Mode
jWhen the play mode selection is set to in the Playback Mode, and it is switched
between the 3D still picture and the 2D still picture
jWhen the 1080/50p, 1080/50i, or side-by-side scenes are switched.
Connecting with the AV multi cable
Select the desired setting of AV multi connector output.
Changing the component output setting
≥ Set [VIDEO LIGHT] to [OFF] when recording with the TV connected to the component
terminal to confirm the recording. (l 53)
: [SETUP] # [HDMI RESOLUTION] # [AUTO]/[1080p]/[1080i]/[576p]
: [SETUP] # [AV MULTI] # desired setting
[COMPONENT]: When connecting to the component terminal
[AV OUT]: When connecting to the video terminal
: [SETUP] # [COMPONENT OUT] # desired setting
[1080i]: When connecting to the component terminal on the TV compatible with
1080i. (Playback is in high definition quality.)
[576i]: When connecting to the component terminal on the TV compatible with 576i.
(Playback is in standard quality.)
To Next Page
Loading...
