- 74 -
4 Adjust the lens attachment part following the instructions on the
screen.
5 Touch [EXIT] to end the adjustment.
≥ When re-attaching the 3D Conversion Lens or after an impact etc., it is
recommended that you perform the adjustment again.
6 (When recording motion pictures)
Press the recording start/stop button to start recording. (l 20)
≥ Start recording after removing the Lens front cap.
(When recording still pictures)
Press the button to record still pictures. (l 22)
≥ appears on the screen.
≥ It is possible to record still pictures while recording motion pictures. (Simultaneous
recording)
≥ The number of recording pixels are (1920k1080). (l 65)
≥ Use of a tripod is recommended for recording with a stable picture.
≥ [ECONOMY (BATT)]/[ECONOMY (AC)] will not work while you adjust the 3D Conversion
Lens attachment position.
≥ When the 3D Conversion Lens is attached, the auto slow shutter setting is [AUTO SLOW
SHTR (3D)]. The default setting of [AUTO SLOW SHTR (3D)] is [ON]. (l 61)
≥ While 3D recording if moving the unit fast, the message is more likely to appear.
≥ The LCD monitor on this unit will not display in 3D.
≥ If the unit is turned on in the shade, etc., the screen may appear to be blue. In such a case,
removing the lens cap will return the screen to normal.
To ensure that the 3D image can be safely viewed, pay attention to the following
points when recording.
≥ Where possible, record with the unit in a horizontal state.
≥ Do not get too close to the subject. (record from a distance of at least 1.2 m.)
≥ When moving the unit as you record, move it slowly.
≥ Try to hold the unit as steady as possible when recording while riding in a vehicle or
walking.
To Next Page
Loading...
