28
VQT1U19
Setup
5
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
-Rotate the mode dial to select .
1 Select the menu. ( 24)
2 Select the date or time to be set,
then set the desired value with
the cursor button.
The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
The 24-hour system is used to display the time.
[ ] appears on the right top of the screen
when [SET WORLD TIME] ( 30) is set to
[HOME], while [ ] appears when it is set to
[DESTINATION].
3 Press the cursor button to enter
the selection.
The clock function starts at [00] seconds when
the cursor button is pressed.
Changing the date and time display mode
Select the menu. ( 24)
[SETUP] [DATE/TIME] desired display
style
You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
Changing the date format
Select the menu. ( 24)
[SETUP] [DATE FORMAT] desired
display style
To set daylight saving time, select the daylight
saving time in [HOME] for [SET WORLD TIME]
after setting the clock.
The date and time function is driven by a built-
in lithium battery.
If the time display becomes [- -], the built-in
lithium battery needs to be charged. Use the
following steps to charge the battery.
[SETUP] [CLOCK SET] [YES]
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008. 11. 15
[M/D/Y] 11 15 2008
[D/M/Y] 15. 11. 2008
15. 11. 2008 12:3415. 11. 2008
To Next Page
Loading...
