Panasonic HDC-HS100 - Changing the Picture Quality on the LCD Monitor; Adjusting the Viewfinder Field of View; Recording Showing the Contents to a Partner

32
VQT1U19
1 Set the AUTO/MANUAL switch to
MANUAL ( 59)
2 Select the menu. ( 24)
[DYNAMIC]:
The image on the LCD monitor becomes clear
and vivid. Optimum contrast and brightness are
set depending on the scenes recorded. Clear
and brilliant images are presented.
[NORMAL]:
Switches to the standard picture quality.
When the brightness of the LCD monitor is
increased (when the [POWER LCD] is set to
[ ] or [ ]), or when the AUTO/MANUAL
switch is set to AUTO, it is set to [DYNAMIC],
and the setting cannot be changed.
Adjust the focus by rotating the
eyepiece corrector dial.
-Rotate the mode dial to select .
Rotate the LCD monitor towards the
lens side.
Both the LCD monitor and the viewfinder are
turned on during the face-to-face recording
regardless of the position of the LCD/EVF
select switch.
The image is horizontally flipped as if you see
a mirror image. (However the image recorded
is the same as a normal recording.)
Record by viewing the image in the viewfinder
during the face-to-face recording.
Only some indications will appear on the
screen. When [!] appears, return the
direction of the LCD monitor to normal position
and check the warning/alarm indication.
( 123)
Following settings cannot be made during the
face-to-face recording. Return the LCD monitor
to normal position before making the settings.
$POWER LCD
$LCD SET
Changing the picture quality
on the LCD monitor
[SETUP] [LCD AI] [DYNAMIC] or
[NORMAL]
Adjusting the viewfinder
field of view
1
+
2
+
Recording showing the
contents to a partner