33
Secondary Settings
∫∫
∫∫
Selecting the paper path for scanned document
To select the front, set the paper path
selector to the upper side.
To select a straight path pass through to the
back, set the paper path selector to the
lower side.
•
When scanning documents with a thickness of
0.2 mm to 1 mm, like folded documents, set the
paper path selector to straight.
∫∫
∫∫
Setting the ADF / manual feed selector
¥ Single scanning
When scanning a single sheet or several
sheets, set the ADF / manual feed selector
to “MANUAL”.
¥ Continuous scanning
When scanning normal paper continuously,
set the ADF / manual feed selector to “2”.
When scanning with smooth sided paper
or a paper jam occurs with normal paper,
set the ADF / manual feed selector to “3”.
When double feeding occurs frequently or
scanning a document with a rough face as
in NCR paper, set the ADF / manual feed
selector to “1”.
When a jam occurs at the paper feed
component, set the ADF / manual feed
selector to “4”.
•
The ADF / manual feed selector must be set in
the chosen specific position for this setting to
function properly.
• If double feed alarm beeps frequently, change
the ADF / manual feed selector.
Paper path selector
The paper path selector is located on the left side of the
scanner.
2
1
3
4
ADF ADJ.
ADF / manual feed selector
MANUAL
The ADF / manual feed selector is located on the left
side of the scanner.
To Next Page
Loading...
