Panasonic KX-F750 - Erasing a Specific Message from Memory; Erasing All Messages from Memory; Room Monitoring

Advanced Instructions
Erasing a specific message from memory
Press X 4 when the message you want to erase is being played.
—The unit will erase the message just played back.
—A long beep followed by three short beeps will be heard. Then the unit
will continue with the next message.
Erasing all messages from memory
You can erase all the recorded messages in the accessing memory.
To erase all messages in mailbox, you must first select the mailbox.
Press X 5.
—A long beep followed by three short beeps will be heard.
—The unit will erase all the recorded messages.
Note:
e The greeting messages will not be erased in this operation.
Room monitoring
You can monitor the sound in the room where the unit is installed. This feature also allows you to speak with
anyone in the room.
Call your unit, then press your remote ANS ID while the greeting message
is playing.
Press
6
after
hearing
a
beep.
—The speakerphone of the unit in the room will be turned on and you can
monitor the room sound for about 30 seconds.
Notes:
e To continue monitoring, press 6 again within 10 seconds after hearing
one beep.
e To talk to the other party in the room, inform them to lift the handset or
press the SP-PHONE button.
Hecording a marker message
After playing back the recorded messages, you can leave an additional message during the same call.
Wait for 3 beeps indicating the end of the remote operation and wait about 10 seconds for another 2 beeps
indicating that the unit is ready for recording, then you can leave your message.
3 beeps
Remote operation a
2 beeps
Marker message (date, time, etc.)
10-second pause
61