Panasonic KX-NCP1000 - Page 48

KX-NT265 (Software version 2.00 or later only)
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
PROG.
Press VOLUME to
select "Subnet Mask".
VOL
Press SP-PHONE. Press SP-PHONE.
Press VOLUME to
select "Default GW".
VOL
Press SP-PHONE. Press SP-PHONE.
The IP-PT will reboot
and can then be
registered to the PBX.
To end programming
Press STORE.
Press HOLD
to return to the
Menu screen.
To enter the IP address of the IPCMPR card (PBX IP Address)
Press HOLD
twice to return
to the Menu screen.
HOLD
Press VOLUME
to select "PBX".
VOL
Press SP-PHONE
twice.
Press
SP-PHONE.
PBX IP
Address
HOLD
IP Address*
1
Press VOLUME to
select "Network".
VOL
Press SP-PHONE. Press VOLUME to
select "DHCP (Disable)".
VOL
Press SP-PHONE
twice.
Press SP-PHONE.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range:
"0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
Note
• IP-PTs can only receive IP addressing information from a DHCP server on its own LAN. Therefore,
when IP-PTs are located on several LANs, a DHCP server is required on each LAN.
• Since the default setting of the DHCP client function is enabled for IP-PTs, simply connect the
IP-PTs to the LAN to use the DHCP server.
48 Getting Started
4.3.1 Assigning the IP Addressing Information