EasyManua.ls Logo

Panasonic KX-NCP500 - Page 24

Panasonic KX-NCP500
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Network Devices
No. Question Answer Memo Ref.
3-a
Can the firewall pass packets
appropriately?
When a firewall is used, make sure to
configure the firewall appropriately to allow
VoIP packets to pass through the network
without being blocked by filtering.
Yes
No
Model of firewall:
p. 20
3-b
Are layer 2 or higher switches used?
Do not use repeater hubs as they can
increase the network load.
Also note that the port of the switching hub
that connects to the MPR/IP-EXT16 cards
should be set to operate under "Auto
Negotiation" mode.
Yes
No
Model of switch:
p. 21
3-c
Are Category 5 (CAT 5) or higher cables
used?
Yes
No
p. 21
QoS (Quality of Service)
No.
Question Answer Memo Ref.
4
Can the router or switch be configured to
use priority control features?
Yes
No
Model of the router/switch:
V-IPGW16 card’s ToS field
setting:
p. 22
24 IP Networking Guide Document Version 2010-08
2.2 VoIP Requirements Checklist

Table of Contents

Other manuals for Panasonic KX-NCP500

Related product manuals