EasyManua.ls Logo

Panasonic KX-NCP500 - Voip Requirements Checklist

Panasonic KX-NCP500
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.2 VoIP Requirements Checklist
Use the following checklists to see if you can implement a VoIP network. The answers identified in underlined
bold-face letters are the required answers for the corresponding questions.
Bandwidth Assessment
No. Question Answer Memo Ref.
1
Does the network have enough
bandwidth to support VoIP
communications?
Make sure that there is more bandwidth
available for VoIP communications than the
amount actually required.
Yes
No
• IP network bandwidth
= kbps
• Available bandwidth for
VoIP
= kbps
• Required bandwidth for
VoIP
= kbps
p. 14
Network Configuration
No.
Question Answer Memo Ref.
2-a
Is the IP network a managed network?
Make sure to use a managed IP network such
as Frame Relay, Leased Line, or IP-VPN
(Virtual Private Network). The MPR/
IP-EXT16 cards are not intended for use on
the Internet (including an Internet VPN).
Yes
No
Type of IP network:
p. 17
2-b Is it possible to have static IP addressing?
Yes
No
p. 17
2-c
Does only a single router provide access
to the IP network?
Yes
No
p. 17
2-d
Does the router not use network address
translation (NAT/NAPT)?
Yes
No
p. 18
2-e
Is there only a single IP network between
2 ends of a call?
Yes
No
p. 19
2-f
Are the network devices located
appropriately for effective VoIP
communications?
It is recommended to connect the PBX as
close to IP telephones and the IP network
interface as possible.
Yes
No
p. 20
Document Version 2010-08 IP Networking Guide 23
2.2 VoIP Requirements Checklist

Table of Contents

Other manuals for Panasonic KX-NCP500

Related product manuals