IP Address*
1
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
Select "Network". Press SP-PHONE. Select "DHCP (Disable)". Press SP-PHONE
twice.
Press SP-PHONE.
Select "Subnet Mask". Press SP-PHONE. Press SP-PHONE.
Select "Default GW". Press SP-PHONE. Press SP-PHONE.
Continued on next page
Press HOLD to return
to the Menu screen.
To enter the IP address of the MPR card in the Primary PBX
(PBX IP Address)
Select "PBX IP
Address".
Press SP-PHONE.
Select "PBX". Press SP-PHONE.
Select "Primary
PBX".
Press SP-PHONE.
Press SP-PHONE.
Press SP-PHONE.
Select "Secondary
PBX".
Press SP-PHONE.
To enter the IP address of the Secondary PBX (if required)
PBX IP Address
PBX IP Address
To Next Page
Loading...
