For IP-PTs connected to the IP-EXT16 Card (KX-TDE series only)
1. Using a DHCP server to automate the assignment of IP addressing information
The IP address of the IP-PT, the subnet mask address, and the default gateway address can be assigned
automatically by the DHCP server.
Only the IP address of the IP-EXT16 card (PBX IP address) must be assigned manually.
Follow the procedure below to assign the PBX IP address.
If you need to set VLAN parameters, follow the procedure described in "4.5.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)/KX-NT136
PBX IP Address
ENTER ENTER
Select "PBX". Select "PBX IP Address". Select "Primary PBX".
ENTER ENTER
To enter the IP address of the IP-EXT16 card (PBX IP Address)
Press
"SETUP"
when it is displayed.
SETUP
To start programming
Supply power to the IP-PT.
To enter the IP address of the Secondary PBX (optional for KX-NT300 with software
version 2.00 or later only)
PBX IP Address
KX-NT300 with software version 2.00 or later only
Select "Secondary PBX".
ENTER ENTER
To the VLAN settings
Press
"STORE".
To end programming
To set VLAN parameters
OR
STORE
The IP-PT will reboot
and can then be
registered to the PBX.
Document Version 2010-08 IP Networking Guide 65
4.5.1 Assigning the IP Addressing Information
To Next Page
Loading...
