Panasonic KX-NCP500 - Page 83

KX-NT300 series (except KX-NT321)
Select "IP Port".
ENTER 7678 ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
1024 – 65535
Port No.
Password
To configure the port number of PTAP Ports
To start programming
Select "PTAP Server Port".
Select "PTAP Server Port".
Select "Primary PBX".
Select "Secondary PBX".
To configure the port number of DHCP Ports
ENTER 1024 – 65535 ENTER
Port No.
Select "PTAP Client Port".
ENTER 67, 1024 – 65535 ENTER
Port No.
Select "DHCP Server Port".
ENTER 68, 1024 – 65535 ENTER
Port No.
Select "DHCP Client Port".
Press "SETUP"
when it is displayed.
SETUP
Continued on next page
1024 – 65535
Port No.
To configure the port number of PTAP Ports for the Secondary PBX (optional for
software version 2.00 or later only)
Software version 2.00 or later only
Document Version 2010-08 IP Networking Guide 83
4.5.4 Configuration of IP Ports