2.4 Connecting to the LAN
2.4.1 Connecting the PBX to the LAN
Refer to the following procedure to connect the PBX to the LAN.
When the PBX is connected to the LAN for the first time, you must assign IP addressing information to the
PBX. Refer to "4.1 Programming the PBX" for instructions.
Note
Make sure to set the port of the switching hub that connects to the PBX to operate under "Auto
Negotiation
" mode.
Connecting the PBX to a Switching Hub
1. Connect the cable to the LAN port of the PBX.
2. Connect the other end of the cable to the switching hub.
To Next Page
Loading...
