Panasonic KX-NS300 - Setting VLAN Parameters

5.7.2 Setting VLAN Parameters
To establish voice communications between IP telephones, the primary ports of the IP telephones and the
connected PBX must belong to the same VLAN. Consult your network administrator and obtain the appropriate
VLAN ID.
If you are using an IP telephone equipped with two ports, it is possible to place primary and secondary ports
of the IP telephone on different VLANs by assigning separate VLAN IDs to each port.
Follow the procedure below for all IP-PTs on the network, using appropriate VLAN IDs.
Note
The procedure for SIP phones may vary depending on the type of the SIP phone being used. Refer to the
documentation of your SIP phone for instructions.
KX-NT300 series (except KX-NT321) and KX-NT500 series (except KX-NT511 and KX-NT551)
Select "VLAN".
ENTER
ENTER
VLAN ID
ENTER
VLAN Priority
*1
1
ENTER
Press "STORE".
To set the VLAN ID for the primary port
To set the VLAN ID for the secondary port
To end programming
0–7
Select "Primary port".
ENTER
VLAN ID
ENTER
VLAN Priority
*1
ENTER
Select
"Secondary port (TO PC)".
Select "VLAN Priority".
ENTER
Return to the
VLAN setting screen.
ENTER
ENTER
Select
"VLAN Priority".
ENTER
Return to the
Menu screen.
Select "Enable" for
VLAN setting.
Select "VLAN ID".
Select "VLAN ID".
0–7
After assigning
the IP addresses
Select "QoS".
ENTER
The IP-PT will reboot
and can then be
registered to the PBX.
1–4094
0-4094 (Only for KX-NT55x)
1–4094
0-4094 (Only for KX-NT55x)
STORE
*1
The VLAN priority of the primary port must be set higher than the priority of the secondary port. The larger the number, the higher
the priority.
Installation Manual 199
5.7.2 Setting VLAN Parameters