Panasonic KX-NS300 - Page 44

Note
• For KX-NT511 users
For details about operating the PROGRAM button and other buttons, refer to "For IP-PTs" in
"4.3.1 Assigning IP Addressing Information".
• To confirm the connection to the secondary PBX after assigning IP addressing information, (1) turn
the IP-PT’s power off, and (2) hold the STORE button and 2 key while turning the power on.
KX-NT265 (Software version 2.00 or later only)
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address (if required)
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
PROG.
Press VOLUME to
select "Subnet Mask".
VOL
Press SP-PHONE. Press SP-PHONE.
Press VOLUME to
select "Default GW".
VOL
Press SP-PHONE. Press SP-PHONE.
To end programming
The IP-PT will reboot
and can then be
registered to the PBX.
Press STORE.
IP Address*
1
Press VOLUME to
select "Network".
VOL
Press SP-PHONE. Press VOLUME to
select "DHCP (Disable)".
VOL
Press SP-PHONE
twice.
Press SP-PHONE.
Press HOLD to return
to the Menu screen.
HOLD
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
• Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-PT is on
a remote office LAN
All of the IP addressing information must be assigned manually.
Follow the procedure below to assign the IP addressing information.
44 Getting Started
4.3.1 Assigning IP Addressing Information