Why doesn't my Panasonic Telephone show a strong radio signal?
If the display on your Panasonic Telephone does not show a strong radio signal even though you are near the CS, the PS user can normally still make calls. The current linked CS is still connected even though another CS is closer.
Why does my Panasonic Telephone System beep during a conversation?
If you hear two short beeps during a conversation on your Panasonic Telephone System, it means the radio signal is weak. Try moving closer to the base unit.
Why does the battery icon flash during a conversation on my Panasonic Telephone?
If the battery icon flashes or beeping tones sound every 5 seconds during a conversation on your Panasonic Telephone, it indicates that the battery is low. Charge the batteries fully.
Why can't I use the handset during a power failure with my Panasonic Telephone System?
The handset will not function during a power failure because the base unit stops emitting radiowaves.
Why doesn't my headset work with my Panasonic Telephone System?
If your headset doesn't work with your Panasonic Telephone System, ensure the headset tone setting is set to on. Also, make sure the headset jack is connected properly.
Why do beep tones sound and '(needs to be charged)' flashes on my Panasonic Telephone System after charging?
If you charged the battery for 7 hours, but the beep tones sound every 5 seconds and '(needs to be charged)' flashes after a few telephone calls, the battery charge contacts may be dirty. Clean the battery charge contacts without damaging them and charge once more. It may also mean it is time to change the battery and replace it with a new one.
What to do if my Panasonic Telephone displays "PS NO CONNECTED"?
If your Panasonic Telephone displays "PS NO CONNECTED", it could be due to several reasons. First, check if the power switch is turned OFF and turn it ON. Second, the PS might be out of range, so try moving closer to the CS. Finally, the radio channel might be busy, or a radio communication error might have occurred, so try again later.
What does "REGISTER UNIT" mean on Panasonic Telephone?
If your Panasonic Telephone displays "REGISTER UNIT", it means the PS is not registered in the system. Consult your dealer.
Why is my Panasonic Telephone PS not working?
If your Panasonic Telephone's PS does not work, it could be because the battery is empty. In this case, charge the batteries fully. If the PS has been cancelled or not registered, you should consult your dealer.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
General| Maximum CO lines | 8 |
|---|---|
| Extensions | 8 |
| Expandable Extensions | 16 |
| Maximum Extensions | 24 |
| Expandable | Yes |
| Caller ID | Yes |
| Call Forwarding | Yes |
| Call Waiting | Yes |
| DISA/OGM | Yes |
| Doorphone Interface | Yes |
| SMDR | Yes |
| Power Failure Transfer | Yes |
| Intercom | Yes |
| Music on Hold | Yes |
| Conference | Yes |
| Door Phone | Yes |
| Type | Digital |
| Lines | 3 |
| Weight | 6.6 lbs |
