Panasonic KX-TDA100 KX-TDA200 - Page 31

1.4 Specifications
Installation Manual 31
MEC Card Calculation
Calculate the MEC figure from the type and total number of items of equipment to be connected. If the MEC
figure exceeds 64 (for KX-TDA100) or 128 (for KX-TDA200), you need to install an MEC card.
MEC Card Calculation
Calculation Example (KX-TDA100)
The total MEC figure is 88. As this exceeds 64, you need to install an MEC card for this configuration.
External Sensor 8 16
External Relay 8 16
Add-on Key Module 64 128 128 256
USB Module 64 128
*1
A single "T1-OPX (Off Premise Extension) port" is counted as a wired telephone.
Equipment Type MEC Figure
PT KX-T7600 series DPT/DSS console 1
Other DPT/DSS console 1
APT 1
IP-PT 1
Extension Card
*1
*1
Only the extension cards that can support SLTs count for the MEC figures.
DHLC8 8
SLC8 8
SLC16 16
MSLC16 16
CS (1 unit) 0
PT-interface CS (1 unit) 0
VPS (1 port) 1
Equipment Type MEC Figure
KX-T7600 series DPT 48 units 48
SLC16 1 card 16
MSLC16 1 card 16
VPS 8 ports 8
Tot a l 88
Terminal Equipment Type
KX-TDA100 KX-TDA200
Without MEC
Card
With MEC
Card
Without MEC
Card
With MEC
Card