Panasonic KX-TDA100D

1.1 Before Operating the Telephones
1.1.1 Before Operating the Telephones
What Kind of Telephone Can Be Used?
You can use a Panasonic
IP Proprietary Telephone (IP-PT) (e.g., KX-NT346 or KX-NT366) and a single line
telephone (SLT), such as a rotary pulse telephone or a Panasonic proprietary telephone (PT) such as the
KX-T7636 or KX-DT346. You can also use a Panasonic Portable Station (PS) such as the KX-TCA255. Use
the feature depending on the telephone you are using. If you are using a Panasonic proprietary telephone with
a special feature button such as
REDIAL
or a display (Display PT) or both, you can follow the operation with the
button or display messages for easy programming.
If you use a large display telephone (e.g.,
KX-NT346 or KX-T7636), you can follow the displayed messages
to use the features. If your telephone does not have feature buttons and/or a display, you may operate the
PBX by entering a feature number instead. Follow the operation for your type of telephone. If you use a Console,
you can use the buttons on the Console as the buttons on the connected proprietary telephone.
• If you use a Panasonic
proprietary
telephone which does
not have feature buttons, you
may change one of the unused
flexible buttons to a feature
button. Refer to
"3.1.3 Customising the Buttons".
Registration for Your Portable Station (PS)
Your
PS must be registered with the PBX and assigned an extension number before initial use, through system
programming. To confirm the extension number of your PS, refer to "Your extension information" in Section
"3.1.2 Settings on the Programming Mode".
Feature Numbers
To
use certain features, you need to enter specified feature numbers (and an additional parameter, if required).
There are two types of feature numbers as follows:
• Flexible feature number
• Fixed feature number
Fixed feature numbers cannot be changed. However, you can change the flexible numbers to other numbers
for easier use. In this manual, the default numbers (factory installed) are used for operations.
A flexible number is shown as
(half-shaded
key). Use the new programmed number if you have changed
the feature number. Write the new number in "4.2.1 Feature Number Table" (Appendix).
Notice
The default value of a flexible feature number may vary depending on country/area.
If you use a single line telephone which does not have the " " or "#" keys;
it is not possible to access features that have " " or "#" in their feature numbers.
16 User Manual
1.1.1 Before Operating the Telephones