Panasonic KX-TDA100D

3.1.2 Settings on the Programming Mode
You can programme features using the programming mode.
– Setting Features
– Clearing Features
• To exit at any time, lift the handset.
• To enter the programming mode when using a PS, refer to
"Operating Instructions" for PS.
Setting Features
The default settings are shown in bold letters. For later reference, place a check mark in the boxes below to
indicate your customised setting.
Notice
The default value may vary depending on country/area.
Follow
programming
input.
To programme To exit To enter the programming mode
Follow Selection
& Parameter.
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
selection &
parameter
programming
input
OR
PROGRAM
PAUSE
OR
PROGRAM
PAUSE
Press ENTER
or STORE.
OR
AUTO DIAL
STORE
Press ENTER
or STORE.
OR
AUTO DIAL
STORE
Item
Programming
Input
Selection & Parameter
Your extension information
0
0
PT: The display shows the PBX number, slot number
and port number.
<example>
EXT1050:10308
PBX no. Port no.
Slot no.
PS: The display shows the PS number.
<example>
EXT3001:99001
PS no.
Display Contrast Selection
*1
Preferred display contrast
level from the 4 levels
available
0
1
1
Light
2
Little Light
3
Little Dark
4
Dark
188 User Manual
3.1.2 Settings on the Programming Mode