Panasonic KX-TDA30

IP-PTs with a multiline display (e.g., KX-NT300 series [except KX-NT321])
PBX IP Address
ENTER ENTER
Select "PBX". Select "PBX IP Address". Select "Primary PBX".
ENTER ENTER
To enter the IP address of the IP-EXT card (PBX IP Address)
Press "SETUP"
when it is displayed.
SETUP
To start programming
Supply power to the IP-PT.
To enter the IP address of the Secondary PBX (optional for KX-NT300 with software
version 2.00 or later only)
PBX IP Address
KX-NT300 with software version 2.00 or later only
Select "Secondary PBX".
ENTER ENTER
To the VLAN settings
Press "STORE".
To end programming
To set VLAN parameters
OR
The IP-PT will reboot
and establish connection
to the network.
STORE
Select "Network".
ENTER
Select "Enable" for
DHCP setting.
To set the IP address of the IP-PT
Return to the
Menu screen.
Information about IP Proprietary Telephones 37
4.2.1 Assigning the IP Addressing Information