Note
• For safety reasons, follow the procedures as indicated when turning on the PBX.
• For safety reasons, do not stretch,
bend, or pinch the AC cord and the DC cable of the AC adaptor.
5. While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the RUN
indicator will stop flashing and stay lit.
All data will be cleared and the PBX will be initialised to the default values. The DPTs should show the time
as 01:00.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1244/Panasonic PSLP1434) and AC cord supplied with
the PBX, or the Additional AC Adaptor (KX-A236).
22 Getting Started
3.1 Starting the PBX
To Next Page
Loading...
