Panasonic KX-TDA30

4.2 Installing the Maintenance Console
For the system requirements of the PC (e.g., operating system, hardware specifications), refer
to "3.3.1 Installing and Starting the Maintenance Console
" in the Installation Manual.
Note
• Make sure to install and use the latest version of the Maintenance Console.
• To connect the PC to the PBX via USB, the KX-TDA USB driver must be installed. Follow the
instructions of the wizard to install
the KX-TDA USB driver. When the PBX is first connected to the PC
via USB, you may be asked to select the appropriate USB driver. Browse for and select the KX-TDA
USB driver that was installed previously.
• The contents and design of the software are subject to change without notice.
• Microsoft product screen shot(s) reprinted with permission from Microsoft Corporation.
1. Copy the setup file of the Maintenance Console to your PC.
2. Double-click the setup file to run the installer.
3. Follow the on-screen instructions provided by the installation wizard.
4.3 Programming the PBX
Starting the Maintenance Console and Assigning the Basic Items (Quick
Setup)
When you start the Maintenance Console with the Installer Level Programmer Code and connect to the PBX
for the first time after initialisation (with the factory default setting), Quick Setup will launch automatically. During
Quick Setup, you will set up the basic items. For details about the basic items, refer to "2.3.4 Quick Setup" in
the Feature Guide.
1. Connect the PC to the PBX with a USB cable or RS-232C
cross cable.
2. Start the Maintenance Console from the Start menu.
3. "Information before programming" appears.
a. Carefully read this important additional information,
which includes updates to this and other manuals.
b. Click OK to close this window.
4.
a. Enter the Installer Level Programmer Code (default:
INSTALLER).
b. Click OK.
5. Click Connect.
Getting Started 25
4.3 Programming the PBX