5. Click MSN Table.
6. Click the MSN tab.
7. Configure the settings as required.
8. Click OK.
Setting an Extension Port to Use a DSS Console
1. Under Configuration, click Slot.
2. Move the mouse pointer over the desired extension card
to display the menu of options.
3. Click Ous to set the card to out-of-service status.
4. Move the mouse pointer over the card again, then click
Port Property.
5. For DPT Type, set the Type to DSS and assign the Lo-
cation No.
6. Click OK .
7. Under Extension, click DSS Console.
8. Select the desired pair extension number from Pair Ex-
tension.
9. Assign features to flexible buttons as required.
10. Click OK.
Getting Started 29
4.3 Programming the PBX
To Next Page
Loading...
