5.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the BRI card, then click
INS to set the card to in-service status.
Assigning the Incoming Trunk Call Destination
For analogue trunk users (DIL Setting):
1. Under CO & Incoming Call, click DIL Table & Port Set-
tings.
2. Confirm that the DIL tab is selected.
3. Configure the settings as required.
4. Click OK.
For ISDN trunk users (DDI Setting):
1. Under CO & Incoming Call, click DDI / DID Table.
2. Configure the settings as required.
3. Click OK.
For ISDN trunk users (MSN Setting):
1. Under CO & Incoming Call, click DIL Table & Port Set-
tings.
2. Click the DDI / DID / TIE / MSN tab.
3. Set the Distribution Method of the desired ports to
MSN.
4. Click OK.
28 Getting Started
4.3 Programming the PBX
To Next Page
Loading...
