Assigning the BRI Setting (Automatic Configuration)
1.
a. Under Configuration, click Slot.
b. Move the mouse pointer over the BRI card.
A menu will be shown under the mouse pointer.
c. Click Ous to set the card to out-of-service status.
2.
Click Tool ® BRI Automatic Configuration from the
menu bar.
3.
a. Click Check to turn on the BRI card.
b. Click OK.
4.
a. Enter the subscriber number for the desired ports in
Subscriber.
b. Click Execute.
Note
Network settings are automatically set.
c. Click Check Box of the desired ports.
d. Click Data Apply.
e. Click Close.
Getting Started 27
4.3 Programming the PBX
To Next Page
Loading...
