Panasonic KX-TG4031C

Programming
22
Programming using the direct commands
1
{MENU} i {#}
2 Enter the desired code.
3 Select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {OFF}.
Note:
L In the following table, < > indicates the default settings.
Feature Code Setting System
*1
Page
Caller list {2}{1}{3} ––30
Play new msg.
(msg.: message)
{3}{2}{3} ––34
Play all msg. {3}{2}{4} ––34
Erase all msg. {3}{2}{5} – r 35
Record
greeting
{3}{0}{2} – r 33
Check greeting {3}{0}{3} ––33
Pre-recorded
(Reset to pre-
recorded greeting)
{3}{0}{4} – r 33
Ring count {2}{1}{1} 2–7 rings <4 rings>
Toll saver
r 36
Recording time {3}{0}{5} 1 min <3 min>
Greeting only
r 37
Remote code {3}{0}{6} <111> r 35
Screen call {3}{1}{0} <On> Off –32
Answer on {3}{2}{7} – r 32
Answer off {3}{2}{8} – r 32
V.M. access
(V.M.: Voice Mail)
{3}{3}{0} ––39
Intercom {2}{7}{4} ––40
Date and time {1}{0}{1} – r 13
Alarm {7}{2}{0}{1}: Once {2}: Daily
{0}: <Off>
–25
Time
adjustment
*2
{2}{2}{6}{1}: <Caller ID auto>
{0}: Manual
r –
Ringer volume
*3
(Handset)
{1}{6}{0}{1}–{6}: Level 1–6 <6>
{0}: Off
––
TG403xC(e).book Page 22 Wednesday, January 13, 2010 1:44 PM