Programming
25
Special programming
Alarm
An alarm sounds at the set time for 3
minutes once or daily. Alarm can be set
for each handset.
Important:
L Set the date and time beforehand
(page 13).
1 {MENU} i {#}{7}{2}{0}
2 {V}/{^}: Select the desired alarm
option. i {SELECT}
3 Enter the desired month and date.
i {OK}
4 Set the desired time.
5 {AM/PM}: Select “AM” or “PM”. i
{OK}
6 {V}/{^}: Select the desired alarm
tone. i {SELECT}
L We recommend selecting a
different ringer tone from the one
used for outside calls.
7 {SELECT} i {OFF}
L When the alarm is set, E is
displayed.
Note:
L To stop the alarm, press any dial key
or place the handset on the base unit
or charger.
L When the handset is in use, the alarm
will not sound until the handset is in
standby mode.
Night mode
Night mode allows you to select a period
of time during which the handset will not
ring for outside calls. This feature is
useful for time periods when you do not
want to be disturbed, for example, while
sleeping. Night mode can be set for each
handset.
Important:
L Set the date and time beforehand
(page 13).
L We recommend turning the base unit
ringer off (page 15) in addition to
turning the night mode on.
L If you have set the alarm, the alarm
sounds even if the night mode is
turned on.
Turning night mode on/off
1 {MENU} i {#}{2}{3}{8}
2 {V}/{^}: Select “On” or “Off”. i
{SAVE}
L If you select “Off”, press {OFF}
to exit.
3 Enter the desired hour and minute
you wish to start this feature.
4 {AM/PM}: Select “AM” or “PM”. i
{OK}
5 Enter the desired hour and minute
you wish to end this feature.
6 {AM/PM}: Select “AM” or “PM”.
7 {SAVE} i {OFF}
L When the night mode is set, 3 is
displayed.
Note:
L To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
Changing the start and end time
1 {MENU} i {#}{2}{3}{7}
Off Turns alarm off. Go to
step 7.
Once An alarm sounds once at
the set time.
Daily An alarm sounds daily at
the set time. Go to step
4.
TG403xC(e).book Page 25 Wednesday, January 13, 2010 1:44 PM
To Next Page
Loading...
